es Parallel Progress form has been improved so that all queued Analysis Series can be viewed using the scroll bar. Previously on the first 14 Analysis Series could be seen due to a vertical scroll-bar limit.
9081 The version number has been changed to v9.0.0 for a new major release. Models from versions prior to v7 will need to be opened and saved in v7 before they can be opened in v9.
9186 An incident was resolved where an abnormal termination could occur if a model with no analysis series defined enters the Run Analyses Parallel task (Analysis phase). This issue was noted to occur for some models that were exported from ETABS.
9217 An incident was resolved where certain models from older versions of Perform-3D (prior to Perform3D v8) would fail to run analyses in parallel after opening in v8, but instead displayed the message "Please set up analysis series run cases first", even though the analysis series were already properly defined.
9192 An incident was resolved where Fluid Damper components with the "Generate Coefficient" option enabled would be corrupted when a model created in Perform3D v7 or a prior version is opened in Perform3D v8. This issue caused the first segment of the generated coefficient to be set to zero and, in Perform3D v8, could be resolved by changing the parameters used to generate the coefficients. This issue has been fixed in Perform3D v9.
9221 An incident was resolved where the "General Wall Results
微博帐号登录